This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.
ITEMLIST
Products Infomation
- Products by Category
- Electronic Measuring Instruments
- EMC / EMI Related
- KYORITSU TECHNOLOGY Line Impedance Stabilization Network TNW-244F2
Line Impedance Stabilization Network
The TNW-244F2 is a Line impedance stabilization network(LISN) used to measure interference voltage leaking from the interference sources due to the power supply line in the frequency range of 9kHz to 30MHz, in compliance with standards such as CISPR (International Special Committee on Radio Interference).
And this LISN can also be measured from single-phase to three-phase, four-wire systems, depending on the number of line phases provided. The measuring lines can also be switched using a remote switch in addition to the switch on the unit.
Additionally, by registering the correction factors of this device into radiation receiver manufactured by Kyoritsu Electronic Industry (KNM-2401, KNM-2402, KNM-2403, and KNM-S243), automatic addition can be performed through key operations, enabling direct reading measurement of interference voltage.
This product is build-to-order model
Line Impedance Stabilization Network
Model:
TNW-244F2
Maker:
Kyoritsu Technology Corporation
Examples of use
1.Using a leakage current breaker on the power line may cause the breaker to trip.
Leakage current of AC100V, 50/60Hz, 400mA flows through the line.
[Countermeasures]
1) Use an isolation transformer.
2) Use a power line without a breaker installed.
2.When switching the measurement circuit, pulses are generated. When combined with a spectrum analyzer, there is a risk of damaging the input circuit of the spectrum analyzer.
[Countermeasures]
1) Using a high-pass filter TFL-009 or TFL-009D.
2) Switching after disconnecting the coaxial cable.
3) Following the requirements of the CISPR standard, inserting a 10dB attenuator inside or outside the lime impedance stabilization network to match the measuring terminals of the instrument to 50Ω. This model supports external attachment for this purpose.
Specifications
| Frequency range | 9kHz to 30MHz |
| Applicable standards | CISPR 16-1-2, VCCI |
| Number of phase | Single, Three-phase 4-wire system |
| Circuit type | 50Ω |
| RF connector | 50Ω（BNC female） |
| Power Line Rating | AC/DC 440V, 100A |
| Standard accessories | Coaxial cable (BNCP-3D2W-BNCP, 5m) ・・・・・1pc. AC power cable (5m) ・・・・・・・・・・・・ 1pc. Remote switch ・・・・・・・・・・・・・・・・ 1pc. Remote switch cable（5m） ・・・・・・・・・・ 1pc. |
| Size | 520(W)x250(H)x420(D)mm |
| Weight | approx.28kg |
Note: Differences from TNW-244F
- Weight and dimensions (smaller and lighter)
- The SAFETY GROUND terminal has been removed.
- Equipped with a standard single-phase outlet on the OUTPUT side
To view the pdf files, the Adobe Reader from Adobe Systems is required.